5 Tools
164
Tools
5
Important • If the default port number is used, it may conflict with other ports. Make sure to set up the
port number that is not in use.
Note • [Added Port Number] cannot be configured if [Port Status] is set to [Disabled].
To configure [Added Port Number], enable port status and reboot the machine, and then
configure [Added Port Number].
EtherTalk
îš„Port Status
Select [Enabled] to use EtherTalk.
Bonjour
îš„Port Status
Select [Enabled] to use Bonjour.
Note • To print from a printer detected by [Bonjour], the LPD port must be activated in advance.
Port 9100
îš„Port Status
Select [Enabled] to use Port9100.
Select this option when the communication protocol is in RAW format for Windows Standard
TCP/IP port monitor.
îš„Port Number
Enter a port number for Port9100 from 1 to 65535.
The default value is 9100.
Important • Do not use the numbers assigned to the other ports.
SNMP
îš„Port Status
Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji
Xerox to control the machine on the network.
FTP Client
îš„Port Status
Select [Enabled] when you use the Scan to PC service with FTP transmission.
Note • Select a communication mode to send data scanned via FTP from [Passive mode] and
[Active mode]. [Passive mode] is selected by default. You can change the setting from
CentreWare Internet Services.
Receive E-mail
îš„Port Status
Select [Enabled] when you receive e-mails and Internet faxes.
Send E-mail
îš„Port Status
Select [Enabled] when you send e-mails and Internet faxes.
E-mail Notification Service
îš„Port Status
Select [Enabled] when you use the E-mail Notification Service. The E-mail Notification
Service notifies you of the machine status or the completion of a print job, and a direct fax job
by e-mail.
Note • [Consumables Status], [Parts Status], [Paper Tray Status], [Output Tray Status],
[Jam Status], [Interlock Status], and [Fault Notice] are notified as the machine
status.
To Next Page
Loading...
Need help?
General
