1 Before Using the Machine
30
Before Using the Machine
1
Assigning Services to Custom Buttons
You can assign services to the <Copy>, <(Not In Use)>, and <Review> buttons on the
control panel.
Assigning a service to a custom button allows you to switch to this service without
having to return to the [Services Home] screen. If you do not need to assign any service
to a custom button, select [(Not Set)].
[Copy] is assigned to the <Copy> button and [Review] is assigned to the <Review>
button at factory, while the <(Not In Use)> button has no assignment.
This section describes how to assign [Send from Folder] to the <(Not In Use)> button,
as an example.
Note • After you change the assignment, apply the labels provided with the machine. When you
assign a service for which no label is provided, use a blank label and write down the service
name with a permanent marker. The labels include the services that are not supported by
the machine.
1 Press the <Log In/Out> button.
2 Enter the system administrator’s user ID with
the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next]
and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3 Select [Tools] on the [Services Home] screen.
Note • When the [Services Home] screen is not
displayed on the touch screen, press the
<Services Home> button.
4 Select [System Settings] > [Common
Service Settings] > [Screen/Button Settings].
To Next Page
Loading...
Need help?
General
