Fuji Xerox DocuPrint CM505 da Administrator's Guide

Error Code
469
Problem Solving
13
072-310
072-311
[Cause] An error occurred in Tray 2.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
073-310
073-311
[Cause] An error occurred in Tray 3.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
074-310
074-311
[Cause] An error occurred in Tray 4.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
077-322
077-323
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
077-327
[Cause] Five or more tray modules are installed.
[Remedy] You can install up to four optional tray modules in the machine.
Remove the unnecessary tray module.
091-312
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
091-316
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
092-316
[Cause] Temperature sensor of the machine detected abnormality.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
092-318
[Cause] Density of Yellow color is low. Drum cartridge or toner cartridge
may not be set properly.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, pull out the drum cartridge [R4] and
the toner cartridge [Y] (yellow), and then insert them again. If the
error still is not resolved, contact our Customer Support Center.
092-319
[Cause] Density of Magenta color is low. Drum cartridge or toner cartridge
may not be set properly.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, pull out the drum cartridge [R4] and
the toner cartridge [M] (magenta), and then insert them again. If
the error still is not resolved, contact our Customer Support
Center.
Error Code Cause and Remedy

Fuji Xerox DocuPrint CM505 da Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CM505 da
Category	All in One Printer
Language	English