13 Problem Solving
480
Problem Solving
13
Other Errors
This section describes the remedies when the following messages are displayed.
Error
Message
Cause and Remedy
A fault has
occurred.
Switch off the
machine.
(xxx-yyy)
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch the machine power on again.
If the message persists, record the content displayed for [(xxx-
yyy)]. Then immediately switch the main power and power off,
make sure that the touch screen is blank, and then contact our
Customer Support Center.
Completed with
an error.
(xxx-yyy)
[Cause] An error occurred, and the operation terminated abnormally.
[Remedy] Execute the operation again.
A fault has
occurred. The
machine has
rebooted.
Select [Close].
If the problem
persists, call for
service.
(xxx-yyy)
[Cause] An auto-recoverable internal error occurred, and the machine
restarted automatically.
[Remedy] Select [Close]. to use the machine normally. If the error still is not
resolved, contact our Customer Support Center.
To Next Page
Loading...
