Fuji Xerox DocuPrint CM505 da Administrator's Guide

13 Problem Solving
492
Problem Solving
13
Stapler Faults
This section describes how to clear stapler troubles when the optional finisher is
installed.
Perform the procedures on the following pages when copies are not stapled or staples
are bent. Contact our Customer Support Center if the problem persists after you have
tried the following solutions.
If copies are stapled as shown in the figures below, contact our Customer Support
Center.
Unstapled
Bent staple
One side of staple rising up
Staple bent in reverse direction
Flattened staple
Entire staple rising up
Staple rising up with
center pressed in

Fuji Xerox DocuPrint CM505 da Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CM505 da
Category	All in One Printer
Language	English