Interface Cables
19
Before Using the Machine
1
Interface Cables
When connecting the machine directly to a computer, use the USB interface. When
connecting the machine to a network, use the Ethernet interface.
Using the USB Interface
The USB interface of the machine supports USB 2.0.
This section describes the installation procedures for the USB interface.
1 Press the power switch to the [ ] position to switch off the power.
2 Make sure that the touch screen is blank and the <Energy Saver> button does not
light up.
3 Press the main power switch to the [ ] position to switch off the main power.
4 Connect a USB cable to the USB 2.0
interface connector.
5 Connect the other end of the USB cable to the computer.
6 Press the main power switch to the [ | ] position to switch on the main power.
7 Press the power switch to the [ | ] position to switch on the power.
8 Restart the computer.
For more information on setting items, refer to "Printer Environment Settings" (P.259).
Using the Ethernet Interface
The Ethernet interface of the machine supports the following three types.
z
1000BASE-T
z
100BASE-TX
z
10BASE-T
This section describes the installation procedures for the Ethernet interface.
1 Press the power switch to the [ ] position to switch off the power.
2 Make sure that the touch screen is blank and the <Energy Saver> button does not
light up.
3 Press the main power switch to the [ ] position to switch off the main power.
To Next Page
Loading...
Need help?
General
