12 Authentication and Accounting Features
360
Authentication and Accounting Features
12
User Authentication Operations
The machine has the Authentication feature to restrict the services available.
This section describes the authentication method to use the restricted services.
The following shows the reference section for each procedure.
Authenticating Login Users ......................................................................................................360
Changing Passcode ...................................................................................................................361
Authenticating Login Users
There are two methods to authenticate login users: using the operator panel of the
machine and touching the smart card to the IC Card Reader.
To authenticate the login users using the operator panel, the user must enter the user
ID. In addition, the passcode entry is also required when [Passcode Entry from Control
Panel] is set to [On] under [Authentication / Security Settings] > [Authentication] >
[Passcode Policy].
For more information on the passcode policy, refer to "Passcode Policy" (P.245).
For more information on user registration from the touch screen, refer to "Create / View User Accounts"
(P.232).
Note • An optional component is required to use this feature. For more information, contact our
Customer Support Center.
Log In/Log Out from the Operator Panel
îš„User Authentication
1 Press the <Log In/Out> button or the login information field on the touch screen.
2 Enter the user ID with the numeric keypad or the keyboard displayed on the screen,
and select [Enter].
When a passcode is required, select [Next] and enter the passcode, and select
[Enter].
Important • Finish user authentication before you cancel the Interrupt mode.
Note • When you select the service restricted, the [Log In] screen may appear. Enter the user ID
and/or the passcode to use the service.
• When the user is authenticated, the <Log In/Out> button is lit.
îš„Logging Out of User Authentication
1 Press the <Log In/Out> button.
Note • You can also log out by pressing the login information field on the touch screen, and then
select [Logout].
• When the user is logged out, the <Log In/Out> button light goes out.
Log In/Log Out by Touching the IC Card Reader (Optional)
îš„User Authentication
1 Touch the smart card to the IC Card Reader.
Important • Be sure to touch the smart card to the IC Card Reader.
To Next Page
Loading...
Need help?
General
