Configuration of E-mail Encryption/Digital Signature
319
Encryption and Digital Signature Settings
11
Configuration of E-mail Encryption/Digital Signature
This section describes how to encrypt e-mails and how to attach a digital signature to
e-mails.
The following shows the reference section for each procedure.
Step1 Configuration on the Machine ....................................................................................... 319
Step2 Configuration on Sender and Recipient ......................................................................... 321
Installation Overview
To encrypt e-mails and attach a digital signature, configure the machine and your
computer as follows:
Note • To encrypt e-mails and attach a digital signature to e-mails between the machine and a
computer, a personal or device certificate for S/MIME of a recipient and the device certificate
of the machine must be set on the computer. Configure the following settings to the
certificates:
- "e-mail address"
- If the certificate contains V3 extension "keyUsage", "digitalSignature" and
"keyEncipherment" must be asserted.
- If the certificate contains V3 extension "extendedKeyUsage", "emailProtection" must be
set.
• Up to 100 addresses can be encrypted with S/MIME.
îš„Configuration on the Machine
Configure a certificate on the machine. No certificate is registered on the machine by
factory default.
Configure the following settings to set up a certificate on the machine.
z
Configuring certificates by CentreWare Internet Services
- Set up HTTPS communications encryption settings, and then configure a
certificate on the machine.
îš„Configuration on Sender and Recipient
To transmit e-mails encrypted by S/MIME and with digital signatures attached, register
the required certificate on equipment of a sender and a recipient.
Step1 Configuration on the Machine
This section describes configuration procedures to set up a certificate with CentreWare
Internet Services.
Note • You cannot use a self-signed certificate created with CentreWare Internet Services
for S/MIME.
Setting up a Certificate using CentreWare Internet Services
To configure a certificate using CentreWare Internet Services, configure the encryption
settings for HTTP communications, and then import a certificate issued by another CA
to enable S/MIME.
For details on how to configure the encryption settings for HTTP communication, refer to
"Configuration of HTTP Communications Encryption" (P.314).
1 Start CentreWare Internet Services.
To Next Page
Loading...
Need help?
General
