3 Maintenance
68
Maintenance
3
6 Hold the new fusing unit by the grips on both sides, and then place the fusing unit onto
the machine.
Important • Hold the fusing unit with both hands so
that you do not drop it.
7 Close the right hand cover.
Note • When closing the right hand cover, put
your hand near the handle as shown in
the illustration, and then push the cover
firmly to the machine.
• If the front cover is not completely closed,
a message will appear and the machine
will remain paused.
8 Switch on the main power, and then switch on the power.
For information on how to switch on the power and the main power, refer to "2 Product Overview" >
"Power Source" in the User Guide.
Replacing Transfer Belt Unit
When the transfer belt unit is near or reaches the end of its life, the following messages
are displayed on the touch screen. Follow the messages.
Note • To prevent electric shock, always turn off the machine and disconnect the power cable from
the grounded outlet before performing maintenance.
Important • Ensure nothing touches or scratches the surface (black-colored film) of the transfer belt unit.
Scratches, dirt, or oil from your hands on the film of the transfer belt unit may reduce print
quality.
• To protect the drum cartridges from overexposure to bright light, close the inner cover within
five minutes. If the front cover remains open for more than five minutes, print quality may
degrade.
1 Make sure that the <Data> indicator light is off and there are no jobs currently in
process.
Message Remaining Page Yield Solution
Consumables need to be
ordered.
Press Machine Status
button and select the
Supplies tab for details.
Approx. 30,000 pages Order the Transfer Belt Kit.
Consumables need to be
replaced.
Press Machine Status
button and select the
Supplies tab for details.
-
Replace the Transfer Belt Kit
with a new one.
To Next Page
Loading...
Need help?
General
