PCL Emulation
531
Appendix
14
PCL Settings List
The following table describes the parameters that can be set with the mode menu.
Parameter
I
tem No. Value
Paper tray 201 Sets the paper tray to be used for printing.
[0] (Default) : Auto
[1] : Tray 1
[2] : Tray 2
[3] : Tray 3
[4] : Tray 4
[5] : Tray 5
Important • When Trays 1 to 4 is selected, the paper size is determined by the
size of paper loaded in the tray, and thus [Paper Size] cannot be set.
Note • When [Auto] is selected and paper of the same size in the same
orientation in multiple trays is loaded, paper will be fed in the order of
Tray 1 J Tray 2 J Tray 3J Tray 4. If paper of the same size is
loaded in multiple trays but in different orientations, feeding of the
paper loaded in the landscape orientation is prioritized.
Auto size 202 Sets the default paper size. Only available when [Paper Tray] is set to
[Auto]. Only cut sheet can be set.
[4] (Default*) : A4
[5] : A5
[15] : B5
[21] : 8.5 × 14”
[22] : 8.5 × 13”
[23] (Default*) : 8.5 × 11”
[25] : Custom Size
[30] : 8K
Important • When Trays 1 to 4 is selected, [Paper Size] cannot be set. The paper
size loaded in the specified tray is displayed.
Note • When Trays 1 to 4 is selected, the paper size is determined by the
size of paper loaded in the tray, and thus [Paper Size] cannot be set.
• Depending on the combination of [Original Size] and [Paper Size], [?]
may be displayed for the magnification. In this case, the document is
printed at a scale of 100%.
Bypass size 203 Sets the default paper size. Only available when [Paper Tray] is set to
[Auto]. Only cut sheet can be set.
[4] (Default*) : A4
[5] : A5
[15] : B5
[21] : 8.5 × 14”
[22] : 8.5 × 13”
[23] (Default*) : 8.5 × 11”
[25] : Custom Size
Orientation 205 Set the orientation of paper.
[0] (Default) : Portrait
[1] : Landscape
2 Sided printing 206 Sets the 2 sided printing.
[0] (Default) : Off
[1] : On
To Next Page
Loading...
Need help?
General
