Replacing Consumables
65
Maintenance
3
20 Close the front cover.
Note • If the front cover is not completely closed,
a message will appear and the machine
will remain paused.
Replacing Staple Cartridge (for Finisher- AB1)
When the optional Finisher-AB1 is installed and the staple cartridge needs to be
replaced, a message appears on the touch screen. When this message appears, load
a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
performance. Use only staple cartridges recommended by Fuji Xerox.
1 Make sure that the machine is not operating,
and open the finisher front cover.
2 Take the staple cartridge out of the finisher.
3 After you take out the staple cartridge, check
inside of the finisher for any remaining
staples.
To Next Page
Loading...
