Error Code
479
Problem Solving
13
133-210
133-211
133-212
133-213
133-214
133-215
133-216
133-217
133-218
133-219
133-220
133-221
133-222
133-223
133-224
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
133-226
[Cause] A country / region code not supported by the machine was
specified.
[Remedy] Contact our Customer Support Center.
133-280
133-281
133-282
133-283
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
133-710
[Cause] When printing the received fax document, the paper loaded on
the bypass tray was used for printing because the specified tray
could not be used.
[Remedy] Take one of the following measures:
z
Load paper available for printing the received fax document:
B5 LEF , A4 SEF , A5 SEF , B5 SEF , 8.5 x 11" SEF ,
8.5 x 13" SEF , 8.5 x 14" SEF , 8.5 x 11" LEF
,
5.5 x 8.5" SEF .
z
Use a paper type available for printing the received fax
document:
plain paper, bond paper, recycled paper, user-defined custom
paper.
z
Confirm the settings by selecting [Tools] > [Fax Service
Settings] > [Fax Control] > [Receiving Paper Size].
1. Select [Receiving Paper Size] > [Tray Mode] to add a tray to be
used for printing the received fax documents.
2. Set up paper so that the tray specified tray in [Tray Mode] can
be used for printing the received fax documents.
If the error still is not resolved, contact our Customer Support
Center.
Error Code Cause and Remedy
To Next Page
Loading...
Need help?
General
