Connectivity & Network Setup
179
Tools
5
îš„Digital Signature - Outgoing Internet Fax
Select whether or not to always add a digital signature to outgoing Internet faxes.You can
also select the setting in which the machine asks to add a digital signature to the Internet fax
whenever you send.
îš„Certificate Auto Store
Select whether or not to automatically store a S/MIME certificate attached with the e-mail
when receiving e-mail from an address registered on the Address Book.
PDF / DocuWorks / XPS Signature Settings
Configure signature settings of PDF / DocuWorks / XPS documents.
îš„Device Certificate
Select a certificate to use for the signature.
For more information on the certificate, refer to "Encryption and Digital Signature Settings" (P.311).
îš„PDF Signature
Select the setting for PDF Signature from [Do not add signature], [Always add visible
signature], [Always add invisible signature], or [Select during send].
îš„DocuWorks Signature
Select the setting for DocuWorks Signature from [Do not add signature], [Always add
signature], or [Select during send].
îš„XPS Signature
Select the setting for XPS Signature from [Do not add signature], [Always add invisible
signature], or [Select during send].
IPSec Settings
Configure the IPSec settings.
Note • For [IKE Authentication Method], [Preshared Key], [DH Group], and [PFS Settings], consult
your network administrator.
îš„IKE Authentication Method
Set the IKE authentication method. Select from [Authenticate by Preshared Key] and
[Authenticate by Digital Signature].
îš„Preshared Key
Enter a preshared key.
This setting is valid when [IKE Authentication Method] is set to [Authenticate by Preshared
Key].
îš„Device Certificate
Select a certificate for IPSec communications.
Set a certificate when [IKE Authentication Method] is set to [Authenticate by Digital
Signature]. A self-signed certificate created by CentreWare Internet Services cannot be used.
For more information on a certificate, refer to "Types of Certificate" (P.312).
îš„IPSec Communication
Select whether or not to enable IPSec communications.
îš„IKE SA Life Time
Specify IKE SA lifetime from 5 to 28800 minutes in 1 minute increments.
Note • The value must be greater than the value set in [IPSec SA Life Time].
îš„IPSec SA Life Time
Specify IPSec SA lifetime from 300 to 172800 seconds in 1 second increments.
Note • The value must be smaller than the value set in [IKE SA Life Time].
îš„DH Group
Set DH group. Select from [G1] and [G2].
To Next Page
Loading...
Need help?
General
