5 Tools
244
Tools
5
îš„Failed Access Log
Set the failure count to detect unauthorized access. An error is logged if authentication fails
the number of times specified here within a predetermined time (10 minutes).
îš„Logout Confirmation Screen
Set whether or not to display a logout confirmation screen every time a user session ends.
îš„User ID for Login
Set whether or not to make the user ID entry field on the user login screen case-sensitive.
When you select [Case Sensitive], authentication is performed using the User ID as
registered (including upper and lower cases). When you select [Non-Case Sensitive],
authentication is performed with case ignored even if the User ID has both upper and lower
cases.
Important • Do not change the setting while a file is stored for the Private Charge Print. Otherwise, you
may encounter problems, such as being unable to print. Change the setting after the
machine prints all the files stored.
îš„Guest User
Set whether or not to permit a guest user when [Login to Remote Accounts] is selected. Set
the guest user passcode from 4 to 12 digits.
îš„Use of Smart Card
Set whether or not to use the smart card when a smart card is connected to the machine.
When [Enabled] is selected, you can set whether or not to control jobs with the smart card for
each feature. Select [Enabled (PKI)] to control the security features only. The smart card is
not used for authentication or job controls.
Note • This feature is displayed when the Custom Authentication Kit (optional) is installed.
îš„Smart Card Link Mode
Set whether or not to require a passcode for smart card authentication.
îš„Smart Card Certificate Verification
Set whether or not to verify the smart cart certificate when a user uses the smart card.　
When [Enabled] is selected, the owner of the smart card is verified not only by PIN code　
verification but by certification verification of the smart card and private key match. In this　
case, the upper level CA certificate of the smart card certification must be registered on the　
machine.
When [Disabled] is selected, the owner of the smart card is verified by PIN code verification.
îš„Smart Card Logout Timing
Select the logout method for smart card authentication when a contactless smart card is used
for authentication.
When [Log Out when Card is Removed] is selected, you can logout from the machine by
removing the smart card from the smart card reader. When [Log Out from Control Panel] is
selected, you can logout by operating the touch screen or control panel.
îš„Save remote accounts in this machine
Select whether or not to save the user information used for remote authentication. While the
user information is saved in the machine, the machine can authenticate the user using the　
information saved in the machine even when the remote server is off.
Note • This setting applies only to a user who is authenticated by smart cards.
îš„Delete Remote Accounts
Select whether or not to delete the user information saved in the machine for remote
authentication. Select from [Do Not Delete], [Weekly], and [Monthly].
For [Weekly], you can set the day and time. For [Monthly], set the date and time.
Note • Note . This setting applies only to a user who is authenticated by smart cards.
To Next Page
Loading...
Need help?
General
