Error Code
409
Problem Solving
13
003-700
[Cause] Too many documents are set in the document feeder after
clearing the paper jam.
[Remedy] Check the output, and then replace the documents that have not
been copied yet.
003-702
[Cause] You tried to copy sides 1 and 2 of a document simultaneously
specifying different Reduce / Enlarge ratio for each side.
[Remedy] Specify the same Reduce / Enlarge ratio for both sides.
003-750
[Cause] Unable to store any documents using the 2 Sided Book Copying
feature.
[Remedy] Check the 2 Sided Book Copying settings.
Refer to "3 Copy" > "Layout Adjustment" in the User Guide.
003-751
[Cause] Unable to process the document because the specified scan area
is too small.
[Remedy] Increase the resolution or scan area.
003-752
[Cause] A mix sized document was to be scanned at 600 dpi in Color/2
sided.
[Remedy] Set [Resolution] to [400dpi] or lower, and try scanning again.
003-753
[Cause] A mix sized document was to be scanned at high resolution, 2
sided.
[Remedy] Set [Resolution] to [200dpi], and scan the document again.
003-754
003-755
[Cause] An error occurred in the document feeder.
[Remedy] Execute the job again.
003-756
[Cause] The faxed document is completely blank.
[Remedy] Check whether the document is blank or whether the side of the
document to be faxed is loaded correctly.
003-757
[Cause] A mix sized document was to be scanned at high resolution, 2
sided.
[Remedy] Set [Resolution] to [300dpi] or lower, and scan the document
again.
003-760
[Cause] An incompatible combination of feature is specified for document
scan conditions.
[Remedy] Confirm the selected options.
003-761
[Cause] The paper size of the tray selected for auto tray differs from the
paper size of the tray selected for Auto Paper selection.
[Remedy] Change the paper size for the tray, or change the [Paper Type
Priority] settings.
003-763
[Cause] An error occurred when reading the Calibration Chart.
[Remedy] Place the Calibration Chart correctly on the document glass.
Refer to "Executing Calibration" (P.87).
003-780
[Cause] Failed to compress the scanned document.
[Remedy] Reduce the resolution or the ratio for [Reduce / Enlarge] to
decrease the data size, or split the data to send it separately.
003-795
[Cause] When enlarging/reducing a scanned document to the paper size
specified, the reduction/enlargement ratio exceeds the allowed
range.
[Remedy] Take one of the following measures:
z
Manually enter a reduction/enlargement ratio.
z
Change the paper size.
Error Code Cause and Remedy
To Next Page
Loading...
