13 Problem Solving
424
Problem Solving
13
016-718
[Cause] Unable to process the PCL print data because of insufficient
memory.
[Remedy] Reduce the resolution, or cancel 2 sided printing or N up feature,
and then print again.
016-719
[Cause] Unable to process the PCL print data because of insufficient print
page buffer.
[Remedy] Increase the size of the print page buffer.
016-720
[Cause] An invalid command is included in PCL print data.
[Remedy] Confirm the print data and try printing again.
016-721
[Cause] An error occurred during print processing. Probable causes are
as follows:
1) Printing was instructed by the Auto Paper selection when
[Paper Type Priority] is set to [Auto Paper Off] for all paper in
the [Common Service Settings].
2) ESC/P-K command error
[Remedy] For 1), when printing by the Auto Paper selection, set one of the
paper types to other than [Auto Paper Off] in [Paper Type
Priority].
For 2), confirm the print data.
Refer to "Paper Tray Priority" (P.142).
016-722
[Cause] The staple position specified is not supported by the machine, or
the paper size specified is not supported by the finisher.
[Remedy] Confirm the staple position and the paper size, and try printing
again.
016-727
[Cause] A print job was cancelled without storing a file into a folder
because the file was determined as not containing any pages.
[Remedy] The file could not be stored into the folder because the machine
determined the print file as not containing any pages. Disable
[Skip Blank Pages] on the [Advanced] tab on the print driver, or
add text to the file if the file is blank.
016-728
[Cause] An unsupported tag is included in the TIFF file.
[Remedy] Confirm the print data.
016-729
[Cause] Unable to print because the number of colors or the resolution of
the TIFF file exceeds the allowed range.
[Remedy] Change the number of colors or resolution for the TIFF file, and
execute the operation again.
016-731
[Cause] Unable to print TIFF data because it was interrupted.
[Remedy] Retry printing.
016-732
[Cause] The form specified by emulation has not been registered at the
host side.
[Remedy] Resend the form data.
016-733
[Cause] Probable causes are as follows:
1) Unable to obtain the IP address (the string after "@" in the
destination e-mail address) when e-mail is sent.
2) DNS server was unable to resolve the Internet address (the
string after "@") by the DNS server when e-mail is sent.
[Remedy] For 1), confirm the e-mail address.
For 2), confirm the DNS server address.
016-735
[Cause] Attempted to print [Job Template List] while updating the job
template.
[Remedy] Retry printing after waiting for a while.
Error Code Cause and Remedy
To Next Page
Loading...
