Fuji Xerox DocuPrint CM505 da Administrator's Guide

Error Code
467
Problem Solving
13
033-732
[Cause] An error occurred while connecting to EP system.
[Remedy] This is an error occurring during maintenance work by Fuji Xerox.
No measure is required.
033-733
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
033-734
[Cause] Because a report job was instructed while preparing to print a
received fax, the printing of the received fax is temporarily
suspended.
[Remedy] No measure is required.
033-735
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
033-736
[Cause] The forwarding job was interrupted because the data volume
exceeded the upper limit.
[Remedy] No measure is required.
033-737
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
033-738
[Cause] Received abnormal JBIG data.
[Remedy] No measure is required.
033-740
[Cause] The printing of the received fax document was interrupted.
[Remedy] No measure is required.
033-741
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
033-742
[Cause] An error occurred during fax transmission. This error may occur if
the remaining capacity of the machine’s memory is 10% or less
and Manual Send is used.
[Remedy] If this error was caused when using Manual Send, connect the
line after storing the document, and then send. If the error still is
not resolved, delete unnecessary data from the hard disk to free
up disk space, and execute the operation again.
If the error persists, contact our Customer Support Center.
033-743
033-744
033-745
033-746
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. Try again. If the
error still is not resolved, contact our Customer Support Center.
033-747
[Cause] The job is temporarily suspended.
[Remedy] No measure is required.
033-749
[Cause] The machine will automatically recover and print the document.
[Remedy] No measure is required.
033-750
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. Try again. If the
error still is not resolved, contact our Customer Support Center.
Error Code Cause and Remedy

Fuji Xerox DocuPrint CM505 da Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CM505 da
Category	All in One Printer
Language	English