2 Paper and Other Media
48
Paper and Other Media
2
4 Insert envelopes until the short-edge of the
envelopes lightly touch against the paper
feed entrance, with the side to be copied or
printed on facing down and the flaps closed.
Important • Do not force envelops into Tray 5.
• Do not load envelops above the
maximum fill line. It may cause paper
jams or machine malfunction.
When Loading COM-10, Monarch, or DL
When Loading C5
Important • Never use windowed, lined, or self-
adhesive envelopes.
• These lead to paper jams and can cause
damage to the printer.
Note • Ensure that you load envelopes with the
flap completely closed.
• If the envelopes set in the Tray 5 are new,
they may bulge. Flatten them to avoid
jams as shown in the illustration.
• If the envelopes are still not loaded
correctly, add some bending to the lead
edge of the envelopes as shown in the
illustration.
The amount of the bending should be
5mm or less.
îš„Using the Tray 5
z
Load only one size and type of print media during a single print job.
z
Do not add or remove the print media when there is still print media in the Tray 5 or
when the machine is printing from the Tray 5. This may result in a paper jam.
To Next Page
Loading...
