14 Appendix
554
Appendix
14
z
Insert a USB memory device directly into the USB memory slot on the control panel.
If you connect a USB memory device via a USB cable, the operation is not
guaranteed.
z
To connect a USB memory device via a USB cable, use the USB 2.0 interface
connector on the rear of the left side of the machine.
îš„IC Card Reader
Installing the IC Card Reader to the machine enhances the authentication function of
the machine. Also, you can restrict the usage of the machine and improve the security
management feature and availability of documents.
îš„Stored Programming
z
The following features and operations cannot be registered on a stored program.
- Registration and call of a stored program
- EP Diagnostic Request
- System Settings
- The [Media Print - Text] and [Media Print - Photos] buttons on the [Services Home]
screen
- The [Store to USB] button on the [Services Home] screen
- The [Network Scanning] button on the [Services Home] screen
- A custom button to which the Network Scanning is assigned
- Address Book for the Fax / Internet Fax, E-mail, and Scan to PC services
- Buttons that cannot be selected
- The [Language] button on the [Services Home] screen
- The [Screen Brightness] button on the [Services Home] screen
- The use of a scrolling bar when you select an item
- The [Browse] button of the Scan to PC service
- Address editing operation of the E-mail service ([Remove], [Edit], and [Close
Menu] on the pop-up menu)
- The <Energy Saver> button
z
After registering a program, you may not be able to retrieve the stored program
correctly if you execute the following operations:
- If a passcode of a folder that is subject to operation by a stored program is
changed after the program is registered
- If the settings of the control panel are changed
- If the features registered on the custom buttons are changed
- If the setting is changed with [Tools] > [System Settings] > [Copy Service Settings]
> [Preset Buttons]
- If the program is selected from a list of a job flow or the Address Book
- If a button no longer functions as a result of a change of optional components such
as Finisher
- If the measurement unit such as mm or inch is changed
- If a file is selected from a file list with Job Status
îš„Software Option
When you buy the Software Option, we provide you with the documentation including
"LICENSE AGREEMENT". Set the software key (passcode) specified on the
documentation for [Tools] > [System Settings] > [Common Service Settings] >
[Maintenance] > [Software Options] on the machine to use the feature.
To Next Page
Loading...
Need help?
General
