Managing units of the SE server Managing hardware
206 U41855-J-Z125-3-76
Displaying FC interfaces of the MU
Ê Select Hardware → Units[ → <se server> (SE<model>)] → <unit> (MU) → Information,
FC interfaces tab:
The FC interfaces tab displays three groups with information on the FC interfaces:
● FC interfaces provides information for each FC interface of the MU on the host controller
used, the plug-in position (slot and port), the Type (firmware and revision status), the
local WWPN (World Wide Port Number) of the FC interface, and the connection
channel to the Server Unit /390 (Channel Path ID - CHPID). The hardware status of the
FC interface is also displayed (UP/DOWN).
● FC targets contains the WWPNs of the FC interfaces on the accessible FC controllers
(targets). The WWPN identifies a port unambiguously worldwide.
● FC paths contains information on the connections between the units and the accessible
FC controllers. Address information on the end points of the various connections is
displayed.
To Next Page
Loading...
Need help?
General