Fujitsu ETERNUS DX S5 Series - RAID Group Creation; Figure 11 RAID Group Creation; Table 4 RAID Group Creation

RAID Group Creation
Create RAID groups (groups of drives that configure RAID in the ETERNUS DX) to create volumes.
Create an operation RAID group and a backup RAID group.
Figure 11
RAID Group Creation
RAID5 (4+1)
600GB
600GB
600GB
600GB
600GB
RAID5 (2+1)
1.92TB
1.92TB
1.92TB
Operation RAID group (RG0) Backup RAID group (RG1)
Table 4 RAID Group Creation
Usage Item Create mode RAID type Configuration drive
Operation RAID group (copy
source)
RG0 Manual RAID5
600GB SAS disk ´ 5
Backup RAID group (copy
destination)
RG1 Manual RAID5
1.92TB SSD ´ 3
• Do not uninstall the drives that are installed by default or move them to any other
slot.
Contact your sales representative or maintenance engineer if drives that are
installed by default need to be uninstalled or moved to another slot.
The procedure to register a RAID group is as follows:
1 On the navigation of the ETERNUS Web GUI screen, click the [RAID Group] tab.
The [RAID Group] screen appears.
2 Click [Create] in [Action].
The [Create RAID Group] screen appears.
3 Enter the name of the RAID group that is to be registered. Select "Manual" for "Create Mode".
6. Configuration Settings for RAID Groups or Thin Provisioning
When Using Standard Volumes
109 Configuration Guide (Basic)