Fujitsu ETERNUS DX S5 Series - When Power Distribution Units (1 U) Are Installed

2 Connect the power cords to the socket.
Connect the plug at the other end of each power cord to the socket.
IMPORTANT
Connecting two power cords for each enclosure to different two power supply facilities improves the
availability of the power supply facilities against failures.
• Do not use the server service outlet to connect a power cord for the
ETERNUS DX.
When Power Distribution Units (1U) Are Installed
The following procedure explains how to connect the power cord when a 1U power distribution unit is installed.
1 Remove the power cord clamps or the cable holders from the power distribution unit.
Power distribution unit
Cable holder
2 Connect the power distribution unit outlets and power supply unit inlets with the power cords (AC output
cables).
The procedure to connect the power supply unit is same as Step 1 in "When No Power Distribution Units
Are Installed" (page 58).
4. Connecting Cables
Power Cord Connection
59 Configuration Guide (Basic)