5. General Settings
This chapter explains how to set up the ETERNUS DX.
■
Initial Settings after Installation
The following settings must be performed when an ETERNUS DX is installed.
● Storage Management
Perform the device information settings and the network connection settings. All of the required settings
can be performed by following the instructions that are displayed when the Initial Setup 1 wizard is used.
● Firewall Settings
Select whether to enable or disable connections for each service that is to be used via the LAN for operation
management.
● RAID Configuration Settings
Register the RAID groups, the volumes, and the hot spares in the ETERNUS DX. For details on these settings,
refer to "6. Configuration Settings for RAID Groups or Thin Provisioning" (page 108).
● Monitoring Settings
Perform the settings to enable constant monitoring of the ETERNUS DX status. For details on these settings,
refer to "8. Monitoring Settings" (page 159).
● Power Control Setup
Perform the ETERNUS DX power control settings. For details on these settings, refer to "9. Power Control
Setup" (page 179).
● Host Interface Management
Perform the settings for SAN connections with the server. For details on these settings, refer to "7. Host
Interface Management" (page 133).
65 Configuration Guide (Basic)
To Next Page
Loading...
