Fujitsu ETERNUS DX S5 Series - Component Names and LED Names; Figure 27 System Operation Panel; Table 12 Status and Meaning of each LED (System Operation Panel)

Component Names and LED Names
This section describes the operation panel of the frontend enclosure.
■
System Operation Panel
The system operation panel on the front of the frontend enclosure has LEDs, an LCD panel, panel keys, and a
Power switch.
Figure 27
System Operation Panel
1 2
4
3
POWER LED
1 LEDs
(Refer to "● LEDs" (page 207).)
2 LCD panel
(Refer to "● LCD Panel" (page 208).)
3 Panel keys
(Refer to "● Panel Keys" (page 210).)
4 Power switch
(Refer to "● Power Switch" (page 210).)
● LEDs
LEDs are lamps that indicate the status of the ETERNUS DX.
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 12
Status and Meaning of Each LED (System Operation Panel)
LED name LED status Meaning
POWER
(green)
Power is supplied.
IDENTIFY
(blinks blue)
The installation location of the frontend enclosure is identified
according to the instruction that is issued from ETERNUS Web GUI or
ETERNUS CLI.
FAULT
(amber)
The ETERNUS DX is in error status.
(blinks amber)
A part of the ETERNUS DX requires preventive maintenance.
A. Component Names
Frontend Enclosures (ETERNUS DX900 S5)
207 Configuration Guide (Basic)