Fujitsu ETERNUS DX S5 Series - 2. Storage System Monitoring; Checking LED Status; Displaying Status via ETERNUS Web GUI

■
Administration Terminal Setup
Check the settings of the Web browser on the administration terminal.
1 Set the IP address and subnet mask of the administration terminal. Set the following values.
IP address: 192.168.1.2
Subnet mask: 255.255.255.0
2 Check the settings of the Web browser.
For details on the required settings, refer to "Configuration Guide (Web GUI)".
LAN Connection Preparation for Operation Management
Completing and Attaching the Network Setting Label
Enter the network setting information on the Network Setting label. Attach the Network Setting label on the
rack wall near the controller enclosure to avoid losing it.
Figure 2
Network Setting Label
Network Setting
:
: . . .
: . . .
:
IP address of MNT port
IP address of FST port
Subnet Mask of FST port
IP address of RMT port
Complete the following items in the Network Setting label.
• IP address of MNT port
Enter the IP address for the MNT port of the ETERNUS DX. The MNT port is a LAN port that is used to perform
operation management connection.
• IP address of FST port
This item is not used. No information needs to be entered for this item.
• Subnet Mask of FST port
This item is not used. No information needs to be entered for this item.
• IP address of RMT port
Enter the IP address for the RMT port of the ETERNUS DX. The RMT port is a LAN port that is used during initial
setup and to connect to the remote support center.
2. Preparation
LAN Connection Preparation for Operation Management
25 Configuration Guide (Basic)