Fujitsu ETERNUS DX S5 Series - Figure 3 ETERNUS DX100 S5;DX200 S5 Rear View of a Controller (Reference)

(1) Remove the connector cover attached to the port of the SFP+ module and open the lever.
SFP+ module
Lever
IMPORTANT
Keep the removed connector cover in a safe place where it will not be lost.
(2) Check the direction of the SFP+ module and insert it all the way into the port cage of the host
interface.
Install the SFP+ module in Port#0 first, and then Port#1.
Figure 3
ETERNUS DX100 S5/DX200 S5 Rear View of a Controller (Reference)
Host interface
(CA#0)
Host interface
(CA#1)
Controller 0
(CM#0)
Port#0
Port#1 Port#0
Port#1 Port#0 Port#1 Port#0 Port#1
Host interface
(CA#0)
Host interface
(CA#1)
Controller 1
(CM#1)
SFP+ module (Insertion direction)
Topside
(3) Close the SFP+ module's lever.
2 Connect a host interface cable to the ETERNUS DX.
Insert the host interface cable connectors in the host interface ports (iSCSI) of Controller 0 (CM#0) and
Controller 1 (CM#1).
4. Connecting Cables
Host Interface Cable Connection
48 Configuration Guide (Basic)