Fujitsu ETERNUS DX S5 Series - Figure 60 Host Interface Ports (ETERNUS DX60 S5); Table 27 Status and Meaning of each LED (Host Interface for the ETERNUS DX60 S5)

■
Host Interface
A host interface is a board that has interface ports to connect a controller to the server.
● ETERNUS DX60 S5
There are five types of host interfaces: FC 16Gbit/s, FC 8Gbit/s, iSCSI 10Gbit/s, iSCSI 1Gbit/s, and SAS 12Gbit/s.
Figure 60 Host Interface Ports (ETERNUS DX60 S5)
iSCSI 10Gbit/s
iSCSI 1Gbit/s
SAS 12Gbit/s
FC
LINK/FAULT LED
LINK/FAULT LED
LINK LED
FAULT LED
Port#0 Port#1 Port#0 Port#1
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 27 Status and Meaning of Each LED (Host Interface for the ETERNUS DX60 S5)
LED name LED status Meaning
LINK/FAULT
(green)
The link between the host interface port (FC or SAS) and the
destination port has been established.
(amber)
The host interface port (FC or SAS) is in error status.
FAULT
(green)
The link between the host interface port (iSCSI) and the destination
port has been established.
LINK
(amber)
The host interface port (iSCSI) is in error status.
A. Component Names
Controller Enclosure
237 Configuration Guide (Basic)