Fujitsu ETERNUS DX S5 Series - Figure 49 2.5 Drives and 3.5 Drives; Table 19 Status and Meaning of each LED (Operation Panel [Controller Enclosure (ETERNUS DX900 S5)]); Table 20 Status and Meaning of each LED (Drive)

The LEDs turn on or blink to indicate the statuses that are listed below.
Table 19
Status and Meaning of Each LED (Operation Panel [Controller Enclosure (ETERNUS DX900 S5)])
LED name LED status Meaning
POWER
(green)
Power is supplied to the controller enclosure.
IDENTIFY
(blinks blue)
The installation location of the controller enclosure is identified
according to the instruction that is issued from ETERNUS Web GUI or
ETERNUS CLI.
FAULT
(amber)
The controller enclosure is in error status.
(blinks amber)
A part of the controller enclosure requires preventive maintenance.
MAINTENANCE
(green)
The controller enclosure is currently under maintenance.
(blinks green)
The controller enclosure is currently under maintenance (from
ETERNUS Web GUI or ETERNUS CLI), or a status check of the ETERNUS
DX is necessary.
READY
(green)
The controller enclosure is available for use.
■
Drives
2.5" drives and 3.5" drives have LEDs.
Figure 49
2.5" Drives and 3.5" Drives
DRIVE READY LED
DRIVE FAULT LED
DRIVE FAULT LED
DRIVE READY LED
2.5" drive 3.5" drive
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 20 Status and Meaning of Each LED (Drive)
LED name LED status Meaning
DRIVE READY
(green)
The drive is in normal status.
(blinks green)
DRIVE FAULT
(amber)
• The drive is in error status.
• The LED light up operation was performed from the ETERNUS CLI
command line in order to identify the drive location.
A. Component Names
Controller Enclosure
229 Configuration Guide (Basic)