Fujitsu ETERNUS DX S5 Series - Connection Setup for Power Synchronized Units

4 In the [Setup Power Management] screen, select [Enable] for [Auto Power], [Power Resume], or both.
5 Click the [Set] button.
A confirmation screen appears.
6 Click the [OK] button.
The Auto Power function and/or the Power Resume function setting is applied.
7 Check the setting completion message and click the [Done] button.
The screen returns to the [System Settings] screen.
Connection Setup for Power Synchronized Units
Refer to "Configuration Guide (Power Synchronized Unit)" for the required settings to use power control by
connecting power synchronized units to an ETERNUS DX.
9. Power Control Setup
Connection Setup for Power Synchronized Units
180 Configuration Guide (Basic)