Fujitsu ETERNUS DX S5 Series - Figure 5 Connecting Cables between Enclosures (When Two Controllers Are Installed)

Figure 5 Connecting Cables between Enclosures (When Two Controllers Are Installed)
I/O module 0
(IOM#0)
I/O module 1
(IOM#1)
DI (IN)
DI (OUT)
DI (IN)
DI (OUT)
I/O module 0
(IOM#0)
I/O module 1
(IOM#1)
DI (IN)
DI (OUT)
DI (IN)
DI (OUT)
Controller 0
(CM#0)
Controller 1
(CM#1)
DI (OUT) DI (OUT)
Controller
enclosure
Drive
enclosure 1
Drive
enclosure 2
Connection configuration between
Controller 0 and the I/O module line 0
Connection configuration between
Controller 1 and the I/O module line 1
The last
DI port
The last
DI port
IMPORTANT
• To help with management of the mini SAS HD cable between enclosures and prevent incorrect
connections, make sure to attach the destination labels to the connectors of the cables.
• When connecting the mini SAS HD cable between enclosures, check the direction of the connector (the
tab must be pointed downward) and firmly insert all the way in.
To disconnect the mini SAS HD cables between enclosures, hold the tab and then pull out the connector.
Tab
4. Connecting Cables
Drive Enclosure Connection
51 Configuration Guide (Basic)