Note
When high-density drive enclosures are installed, fasten the high-density drive enclosure cable between
enclosures with the clamp belts to the flap brackets and the cable management arm on the rear of the
device.
Clamp belts
Clamp belts
Flap bracket
Cable management arm
The following procedure explains how to connect the mini SAS HD cable between enclosures.
1 Attach the destination labels to the connectors of the mini SAS HD cables between enclosures.
(1) Before attaching the destination labels, check the connection destination of the mini SAS HD cables
between enclosures.
• The connector on which the "n" symbol is printed is connected to the DI (OUT) port on the
controller enclosure or the drive enclosure.
• The connectors on the cable with the "l" symbol are connected to the DI (IN) ports on the drive
enclosure.
4. Connecting Cables
Drive Enclosure Connection
52 Configuration Guide (Basic)
To Next Page
Loading...
