Fujitsu ETERNUS DX S5 Series - Administration Terminal Connection; Figure 6 Administration Terminal Connection for Initial Setup

Drive enclosure 2
Drive enclosure 1
Administration Terminal Connection
Connect an administration terminal to the ETERNUS DX.
Connect the administration terminal to the RMT port of Controller 0 (CM#0) on the controller enclosure directly
with the LAN cable (for operation management).
For the setup information of the administration terminal, refer to "Preparation and Setup for the Administration
Terminal" (page 24).
Note
The ETERNUS DX and the administration terminal must be connected directly since the network
environment of the ETERNUS DX is set using the administration terminal for the initial setup of the
ETERNUS DX.
Figure 6 Administration Terminal Connection for Initial Setup
Administration terminal
LAN cable
LAN port
Controller
enclosure
RMT port of Controller 0 (CM#0)
4. Connecting Cables
Administration Terminal Connection
56 Configuration Guide (Basic)