Fujitsu ETERNUS DX S5 Series - Modify Port Parameters; Modify FC Port Parameters

Modify Port Parameters
This function sets the parameter for the ETERNUS DX side host interface port. The settings vary depending on the
following port types.
• Modify FC Port Parameters
• Modify iSCSI Port Parameters
• Modify SAS Port Parameters
Modify FC Port Parameters
This function sets the parameters for the FC host interface port that connects between the ETERNUS DX and the
host.
Caution
When changing port parameters during operation, stop access from the server that is connected to the
target port. Host access does not need to be stopped to change the port parameters of newly added
Channel Adapter (CA) ports.
The procedure to set FC port parameters is as follows:
1 Select which FC port to set the parameters for (multiple selections can be made) and click [Configure FC
Port] in [Action].
The [Modify FC Port Parameters] screen appears.
7. Host Interface Management
Modify Port Parameters
137 Configuration Guide (Basic)