Initial Setup 1
This section explains Initial Setup 1. Refer to "System Settings" in "ETERNUS Web GUI User's Guide" for details.
1 Set Storage System Name
Register the name, administrator, and installation site of the ETERNUS DX.
2 Change User Password
Change the password for the default account that is currently logged in before starting to use the ETERNUS
DX.
3 Set Thin Provisioning
If using the Thin Provisioning function, select "Enable" and set the maximum pool capacity.
4 Register Advanced Copy License
If using the Advanced Copy function, register the license here.
5 Register SED Authentication Key
Register the Self Encrypting Drive (SED) Authentication Key to enable encryption of the SEDs.
6 Setup Network Environment
Set the environment for the ETERNUS DX to communicate on the network such as IP address and subnet
mask.
Log out when the settings are complete. Log in again, and then proceed to "Initial Setup 2 (Optional)" (page
85).
The procedure to perform Initial Setup 1 is as follows:
1 Click [Initial Setup] in [Action].
Note
The [Initial Setup] screen is displayed after logging in for the first time.
5. General Settings
Initial Setup
76 Configuration Guide (Basic)
To Next Page
Loading...
