Fujitsu ETERNUS DX S5 Series - Figure 42 Rear View of a Controller Enclosure (When the ETERNUS DX100 S5;DX200 S5 Is Installed with Two Controllers)

259 pages

To Next Page

To Previous Page

Figure 42

Rear View of a Controller Enclosure (When the ETERNUS DX100 S5/DX200 S5 Is Installed with Two

Controllers)

1 1

2 4 5 3 5 32 3 46 6

PSU#0 PSU#1

CA#0

CM#0 CM#1

CA#1 CA#0 CA#1

1 Controller (CM#0, CM#1) (refer to "■ Controllers" (page 230))

2 PWC port

This port is used to connect a power synchronized unit with an RS232C cable.

3 Host interfaces (CA#0, CA#1) (refer to "■ Host Interface" (page 237))

4 Drive interface (OUT) port

This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between

enclosures.

5 RMT (LAN) port

This port is used for connecting a LAN cable and used for separating the network (such as for the remote

support) from the MNT port for operation management. This port uses an RJ-45 connector.

6 MNT (LAN) port

This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45

connector.

7 Power supply units (PSU#0, PSU#1) (refer to "■ Power Supply Units" (page 235))

A. Component Names

Controller Enclosure

222 Configuration Guide (Basic)

Other manuals for Fujitsu ETERNUS DX S5 Series