Power Distribution Unit Installation
This section describes how to install a power distribution unit in a rack.
• Do not connect any devices other than the ETERNUS DX to the power distribution
unit.
Installing Power Distribution Unit (1U)
This section describes how to install a 1U power distribution unit in a rack.
1 Attach the M6 cage nuts to the rear rack pillar.
• Attachment positions
On either side, insert four M6 cage nuts in the 1st and 3rd holes above the power distribution unit base
line.
Power distribution unit1U
(Rack pillar: rear)
Power distribution unit
base line
[Left] [Right]
1st hole
3rd hole
M6 cage nut M6 cage nut
1st hole
3rd hole
• Attachment procedure
Clip the M6 cage nut tabs into the desired hole from the inside.
Side view
M6 cage nut
Rack pillar (square hole)
2 Attach the cable holders to the power distribution unit.
Use four M3 screws to attach the cable holders.
3. Rack Installation
Power Distribution Unit Installation
30 Configuration Guide (Basic)
To Next Page
Loading...
