Fujitsu ETERNUS DX S5 Series - Page 31

Cable holder
M3 screw
M3 screw
M3 screw
3 Install the power distribution unit in the rack.
Use four M6 screws to fasten it in the rack pillar.
(Rack pillar: rear)
M6 screw
M6 screw
4 Attach the blank panel to the front side of the rack.
The blank panel should be attached at the same height as the power distribution unit.
(Rack pillar: front)
Blank panel
(Rack pillar: rear)
Power distribution unit
3. Rack Installation
Power Distribution Unit Installation
31 Configuration Guide (Basic)