Fujitsu ETERNUS DX S5 Series - 10 System Status Check; Checking the Component Status

10. System Status Check
Check the status of the ETERNUS DX on the ETERNUS Web GUI screen or ETERNUS CLI.
Checking the Component Status
The status of the ETERNUS DX can be checked by general status in the upper left of the ETERNUS Web GUI screen.
When the general status image is "
", the ETERNUS DX is in normal status. When the general status
image is other than " " (" ", " ", etc.), an abnormality has been detected in the ETERNUS
DX. Check the status of each component on the [Storage] screen.
Display example (ETERNUS DX500 S5)
If there is a component in Warning or Error status, contact your sales representative or maintenance engineer.
182 Configuration Guide (Basic)