LED name LED status Meaning
DI (OUT) LINK/FAULT
(green)
The link between the DI (OUT) port and the destination port has been
established.
(amber)
• The link between the DI (OUT) port and the destination port is in
error status.
• The ports to remove the cables between enclosures from are
indicated. This occurs while a drive enclosure is being added.
(blinks amber)
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
READY/FAULT
(green)
The controller is in normal status.
(blinks green)
An error has occurred during startup.
(amber)
• The controller is performing the initial setup after the power is
turned on.
• The controller is in error status.
(blinks amber)
MASTER
(green)
The controller is set as a Master CM.
CA FAULT
(amber)
The host interface is in error status.
LINK/FAULT
(green)
The link between the host interface port and the destination port has
been established.
(amber)
The host interface port is in error status.
LAN ACT
(blinks green)
Data is being sent or received via the LAN port.
LAN LINK
(green)
The link between the LAN port and the destination port has been
established.
● ETERNUS DX500 S5/DX600 S5
Figure 54
Controller (ETERNUS DX500 S5)
DI (OUT) LINK/FAULT LED
READY/FAULT LED
MASTER LED
BUD READY LED
IDENTIFY LED
LAN ACT LED
LAN LINK LED
BUD FAULT LED
A. Component Names
Controller Enclosure
232 Configuration Guide (Basic)
To Next Page
Loading...
