Fujitsu ETERNUS DX S5 Series - Rear; Figure 39 Rear View of a Controller Enclosure (When the ETERNUS DX60 S5 Is Installed with Only One Controller); Figure 40 Rear View of a Controller Enclosure (When the ETERNUS DX60 S5 Is Installed with Two Controllers)

Rear
This section provides the names of the components in the rear of a controller enclosure.
■
ETERNUS DX60 S5
Figure 39
Rear View of a Controller Enclosure (When the ETERNUS DX60 S5 Is installed with Only One
Controller)
1
2 4 5 63
8 8
PSU#0 PSU#1
CM#0
7
1 Controller (CM#0) (refer to "■ Controllers" (page 230))
2 PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
3 Host interface
This interface is used for connecting a controller with a server.
4 Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
5 RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
6 MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
7 Cover
Remove this when installing an additional controller (optional).
8 Power supply units (PSU#0, PSU#1) (refer to "■ Power Supply Units" (page 235))
Figure 40 Rear View of a Controller Enclosure (When the ETERNUS DX60 S5 Is Installed with Two Controllers)
1 1
2 4 5 63 2 4 5 6
7 7
PSU#0 PSU#1
CM#0 CM#1
3
A. Component Names
Controller Enclosure
219 Configuration Guide (Basic)