Fujitsu ETERNUS DX S5 Series - E-Mail Setup

A confirmation screen appears.
(3) Click the [OK] button.
A dialog box to download the file appears.
(4) Click the [Save] button.
The MIB file is saved.
(5) Check the setting completion message and click the [Done] button.
The screen returns to the [Network] screen.
E-mail Setup
If an event occurs in the ETERNUS DX, the event information is reported to the specified e-mail address.
Note
• Up to five e-mail addresses can be set.
• Make sure to check whether the e-mail messages are received correctly after the e-mail notification
environment setup is complete.
• E-mail messages are not sent again when a communication error occurs between the ETERNUS DX and
the SMTP server.
The e-mail setting is explained below.
1 On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2 In [Category], click [Network].
The [Network] screen appears.
3 In [Action], click [Setup E-Mail Notification].
The [Notification E-Mail] tab screen of the [Setup E-Mail Notification] screen appears.
8. Monitoring Settings
Various Notification Settings
167 Configuration Guide (Basic)