Fujitsu ETERNUS DX S5 Series - Figure 61 Host Interface Ports (ETERNUS DX100 S5;DX200 S5); Table 28 Status and Meaning of each LED (Host Interface for the ETERNUS DX100 S5;DX200 S5)

● ETERNUS DX100 S5/DX200 S5
There are nine types of host interfaces: FC 32Gbit/s, FC 16Gbit/s, iSCSI 10Gbit/s (10GBASE-SR/10GBASE-CR),
iSCSI 10Gbit/s (10GBASE-T), iSCSI 1Gbit/s, SAS 12Gbit/s, Ethernet 10Gbit/s, and Ethernet 1Gbit/s.
Figure 61
Host Interface Ports (ETERNUS DX100 S5/DX200 S5)
iSCSI 10Gbit/s (10GBASE-T)
iSCSI 1Gbit/s
SAS 12Gbit/s
FC 2 ports
iSCSI 10Gbit/s (10GBASE-SR)
iSCSI 10Gbit/s (10GBASE-CR)
Ethernet 10Gbit/s
(for Copper Twinax cable connection)
Ethernet 1Gbit/s
FC 4 ports
FC 2 ports
LINK LED
FAULT LED
LINK/FAULT LED
LINK/FAULT LED
LINK/FAULT LED
LINK/FAULT LED
LINK/FAULT LED
LINK/FAULT LED
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 28 Status and Meaning of Each LED (Host Interface for the ETERNUS DX100 S5/DX200 S5)
LED name LED status Meaning
LINK/FAULT
(green)
The link between the host interface port (FC or SAS) and the
destination port has been established.
(amber)
The host interface port (FC or SAS) is in error status.
A. Component Names
Controller Enclosure
238 Configuration Guide (Basic)