Firewall Settings
Configure the firewall for each service. The settings are required respectively for the MNT port and the RMT port.
Caution
• If both HTTP connection and HTTPS connection are disabled, the ETERNUS DX is inaccessible via ETERNUS
Web GUI.
• If both Telnet connection and SSH connection are disabled, the ETERNUS DX is inaccessible via ETERNUS
CLI.
• If the network environment for the MNT port is not set up, some functions will be unusable. Make sure
to set up the network environment.
1 Start the Web browser and log in to ETERNUS Web GUI with the IP address that is set in Step 8 in "Initial
Setup 1" (page 76).
2 Click the [System] tab on the navigation of the ETERNUS Web GUI screen.
3 Click [Network] in [Category].
The [Network] screen appears.
4 Select the port to be set. Click [Setup Firewall] in [Action].
5 In the [Setup Firewall] screen, specify whether to enable/disable each service.
To enable a service, select the checkbox for that service.
5. General Settings
Initial Setup
83 Configuration Guide (Basic)
To Next Page
Loading...
