Note
The serial number of the ETERNUS DX is required to obtain a Veeam Storage Integration license
and FUJITSU Plug-In for Veeam Backup & Replication.
- Register the Veeam Storage Integration license.
Refer to "License Registration" in "Operation Guide (Basic)" for details.
- If the backup proxy is connected to the ETERNUS DX via an FC, configure the host affinity settings for the
backup proxy using ETERNUS CLI.
For the host affinity settings of the backup proxy, refer to "ETERNUS CLI User's Guide".
• Installation of FUJITSU Plug-In for Veeam Backup & Replication
Install FUJITSU Plug-In for Veeam Backup & Replication to Veeam Backup & Replication.
For details about how to install FUJITSU Plug-In for Veeam Backup & Replication and use Veeam Backup &
Replication, refer to the Veeam Backup & Replication manual that is provided by Veeam Software.
Caution
• If a volume has several snapshot generations and these snapshots have been created with different
resolutions, only the oldest snapshot generation can be deleted.
• The following volumes cannot be managed or operated by Veeam Backup & Replication:
- Volumes used for the Storage Cluster function (note that these volumes are not supported in the
ETERNUS DX60 S5)
- Virtual Volumes (VVOLs) (note that VVOLs are not supported in the ETERNUS DX60 S5)
- Volumes with SnapOPC or EC Advanced Copy sessions
- Volumes with SnapOPC+ sessions created by ETERNUS SF AdvancedCopy Manager
• Veeam Backup & Replication jobs or operations may fail during a firmware upgrade, a RAID
migration, a Thin Provisioning Volume balancing, or a Flexible Tier Pool balancing.
• It is not recommended to use multiple Veeam Backup & Replication for managing a single ETERNUS
DX.
In such configuration, an error might occur at the jobs that are in conflict with each other when
being executed from multiple Veeam Backup & Replication.
11. Solution Configuration
Virtualization Platform
200 Configuration Guide (Basic)
To Next Page
Loading...
