112
Chapter 4 Manual OS Installation
` This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.
5 Install the Drivers for the array controller manually.
1. When the following message appears, press the [S] key.
2. When the "Please insert the disk labeled Manufacturer-supplied hardware support
disk into Drive A:" message appears, press the [Enter] key.
The following message appears.
3. Select the following and press the [Enter] key.
4. When the following message appears, press the [S] key.
5. Follow the instructions in the window to perform installation
The message which prompts you to set the floppy disk appears during the installation, set
the driver disk and push the [Enter] key.
6 Follow the instructions from the setup program to continue the installation
procedure.
If a message indicating that the driver has not passed Windows Logo testing to verify its
compatibility with Windows appears, select [Yes] to continue the installation procedure.
7 Install the ChipSet driver.
1. Insert the ServerStart Disc 1 CD-ROM into the drive of the server.
When the ServerStart window appears, exit ServerStart.
2. Execute the following command on the CD-ROM.
[CD-ROM drive] :\DRIVERS\ChipSet\Intel\Intel3000\infinst_autol.exe
The installation wizard starts up.
3. Click [Next]. Follow the instructions in the window to perform installation.
To specify additional SCSI adapters, CD-ROM drives, or
special disk controllers for use with Windows, including
those for which you have a devicesupport disk from a mass
storage device manufacturer, press S.
You have chosen to configure a SCSI Adapter for use with
Windows, using a device support disk provided by an
adapter manufacturer.
Select the SCSI Adapter you want from the following list,
or press ESC to return to the
previous screen.
LSI Logic Fusion-MPT SAS Driver (Server 2003 x64)
The driver you provided seems to be newer than the Windows
default driver. Windows already has a driver that you can
use for "MEGARAID SCSI 320-0X RAID Controller Driver"
Unless the device on the floppy disk, you should use the
driver in Windows.
To Next Page
Loading...
