Fujitsu Primergy TX120 User Manual

31
PRIMERGY TX120 User’s Guide
1
Overview
4 Press the power switch on the front of the server.
The server's power LED is lit green.
When the power is turned on, the server performs Power On Self Tests (POST). If any
abnormalities are detected by POST, error messages are displayed ("9.2.2 Error Messages"
(
Jpg.217)).
` The time to turn the server off can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView. For details, refer to
"3.4 Serious Error Handling (ASR)" in "ServerView User’s Guide."
` If you press the [F12] key right after the POST memory amount check, the Boot Menu is displayed,
where you can change the boot disk ("
 How to Start the BIOS Setup Utility" (Jpg.191)).
1.4.3 Turning Off the Server
1 Open the drive cover.
J"1.4.1 Opening the Drive Cover" (pg.29)
• In the event of smoke or sparks, immediately unplug the electric cord.
Failure to do so could lead to a fire or electrocution.
• Follow the procedures below to turn off the server. Data can be lost if
these procedures are not followed correctly.
The server's power
LED is lit green

Fujitsu Primergy TX120 Specifications

General

Brand	Fujitsu
Model	Primergy TX120
Category	Server
Language	English