201
PRIMERGY TX120 User’s Guide
8
Configuring Hardware and utilities
8.2.9 Power On/Off Submenu
Use this submenu to configure power On/Off settings.
Discard Timer Mode 1024 clocks
(Unchangeable)
Configures the delayed transfer of PCI bus burst
transfer.
SMART Device Monitoring
Enabled (Unchangeable) Sets whether or not to monitor SMART device.
High Precision Event Timer
• Disabled (Initial value)
•Enabled
Sets whether or not to use the high precision timer
of the chipset.
table: Items on the Power On/Off Submenu
Item Setting Description
Power On Source BIOS Controlled
(Unchangeable)
Configures the power-on setting.
Remote • Disabled (Initial value)
•Enabled
Sets whether or not the power is turned on when
the modem (connected to the serial port) receives
a ring signal.
LAN • Disabled
• Enabled (Initial value)
Sets whether or not to enable the power to be
turned on via LAN.
Wake Up Timer
Disabled (Unchangeable)
Sets whether or not the power is turned on at a
certain time or after a certain time has passed.
table: Items on the Advanced System Configuration Submenu
Item Setting Description
Item Specific Help
Change Values-/+
F10
Select Item
Select Menu
Select Sub-MenuEnter
F1
Esc
Help
Exit
F9
Setup Defaults
Save and Exit
Advanced Security Server ExitMain
Power On/Off
Power on Source:
Remote:
LAN:
Wake up Timer:
Wake up Time:
Wake up Mode:
Power Off Source
Power Button:
Power Failure Recovery:
[Bios Controlled]
[Disabled]
[Enabled]
[Disabled]
[00:00:00]
[Dally]
[Enabled]
[Previous State]
To Next Page
Loading...
Need help?
General