132
Chapter 5 Operations after OS Installation
5.3.1 Storing the BIOS Information and the Remote
Management Controller Information
Store the BIOS information and the Remote Management Controller information according to the
following procedures.
` Before starting the operation, if the "OS Boot Monitoring" function of ServerView is enabled, disable it
(it is disabled by default).
If you start up the system while the "OS Boot Monitoring" function remains effective, the operation of
the server may become unpredictable at such times as an abrupt power interruption or restart.
If it is necessary to operate the server with the "OS Boot Monitoring" function enabled, enable the
function after storing the BIOS/Remote Management Controller information.
For details of ServerView, refer to "ServerView User’s Guide".
1 Turn on the server and insert the "Server Management Tools" disk into the
floppy disk drive.
The window for selecting a keyboard appears.
2 Select a keyboard.
Select [1] for Japanese keyboard or select [2] for English keyboard. Japanese keyboard is
selected by default.
3 When the DOS prompt window appears, enter the following command and
press the [Enter] key.
A:\ SMT\>biossave.bat
4 If the BIOS information or the Remote Management Controller information is
stored correctly, the following message appears.
5 Confirm that the stored information files are created.
Enter the following command to display the stored information files which are created.
A:\SMT>dir
The BIOS information has been stored. The server can now be turned off safely.
Please select:
1 = JP Keyboard
2 = US Keyboard
Your selection
Success !
To Next Page
Loading...
Need help?
General