Fujitsu Primergy TX120 - Preparation for Using Remote Management Controller

253
PRIMERGY TX120 User’s Guide
Appendix
D.2 Preparation for Using Remote Management
Controller
To enable the Remote Management Controller, perform the following procedure.
• Configuring the BIOS
• Connecting the Server to a PC
 Configuring the BIOS
To use the function of the Remote Management Controller, perform the following setting using the
BIOS Setup Utility.
1 Turn on the server. Press the [F2] key during POST to start up the BIOS Setup
Utility.
2 Select the [Advanced] menu → [IPMI] → the [LAN Settings] submenu, and set
the each item.
.For setting items, refer to " LAN Settings Submenu" (Jpg.203).
3 From the [Exit] menu, select [Saving Changes & Exit] to exit the BIOS Setup
Utility.
` Save the setting information of set parameters using the Server Management Tools.
For details, refer to "5.3 Storing the System Configuration Information"( → pg.131).
 Connecting the Server to a PC
Connect the server to a PC using a LAN cable.
㪧㪚㩷㪩㪼㪸㫉
㪟㪬㪙
㪣㪘㪥㩷㪚㪸㪹㫃㪼
㪩㪼㫄㫆㫋㪼㩷㪤㪸㫅㪸㪾㪼㫄㪼㫅㫋㩷㪚㫆㫅㫋㫉㫆㫃㫃㪼㫉㩷㪧㫆㫉㫋
㪣㪘㪥㩷㪧㫆㫉㫋
㪪㪼㫉㫍㪼㫉㩷㪩㪼㪸㫉