Fujitsu Primergy TX120 User Manual

117
PRIMERGY TX120 User’s Guide
4
Manual OS Installation
4.3 Installing the LAN Driver
This section explains the procedure for installing the driver.
In addition to the case where the OS is installed manually, the driver must be
installed when a LAN card is added.
 Checking the LAN device after OS installation
The LAN driver installation procedure differs depending on whether the network adapter was
recognized during the OS installation. Check whether or not a recognized network adapter is present by
the following procedures in advance.
1 Click [Start] → [Administrative Tools] → [Computer Management].
2 Click [Device Manager].
On the Device Manager list, check if a recognized network adapter is present.
(Window example)
When a recognized network adapter is present, [Network adapters] appears.
z When a recognized network adapter is present
For Windows Server 2003 x64
Perform " Updating the LAN Cards" (Jpg.119) on the LAN device name under [Network adapters],
then "
 Installing the LAN Driver" (Jpg.119) on [Ethernet controller] under [Other devices].
For Windows Server 2003
Perform " Updating LAN Drivers" (Jpg.120) on the LAN device name under [Network adapters],
then " Installing the LAN Driver" (Jpg.121) on [Ethernet controller] under [Other devices].
Recognized
network adapte
r
Unrecognized
network adapte
r

Fujitsu Primergy TX120 Specifications

General

Brand	Fujitsu
Model	Primergy TX120
Category	Server
Language	English